[cgi.ebay.com]
I decided to sell my expensive parts because I need the money to pay for classes. I still have my ole j-head and printrboard, so I won't be completely out of commission.
"I am selling a Genuine Budaschnozzle 1.1 Hotend Assembly which takes 3mm plastic filament with a 0.5mm nozzle and an UltiMachine Assembled RAMPS 1.4 electronics with 4 stepper drivers(can be upgraded to 5 for 2 extruders) which have a total value of $280. Both are in perfect working condition and have been used no more than 50 hours without a problem. I am selling these parts just to help pay for college and the fact that I will not have time to 3D print while classes are in session.
The hotend is currently wired for the RAMPS and wire-length accomodates the Prusa i2. If you have a different printer such as the i3,lulzbot or MM2, you may have to re-wire the hotend to fit your needs. I will include the mechanical endstops and wires but I cannot provide the stepper motor wires and connectors because they are permanently wired to my motors, visit UltiMachine.com to order any missing connectors/wires.
What you will receive:
Budaschnozzle 1.1 Hotend 3mm/0.5mm (wired for this board)
Ramps 1.4 Electronics w/4 Stepper Drivers and Arduino MEGA 2560
USB Cable
3 Mechanical Endstops(already wired)
Power Connector
Note to Buyer:
I expect you to already have knowledge of these parts and RepRap. You should already know how to flash and wire these boards. I will not issue a refund for lack of knowledge, I will point you in the right direction however."
I decided to sell my expensive parts because I need the money to pay for classes. I still have my ole j-head and printrboard, so I won't be completely out of commission.
"I am selling a Genuine Budaschnozzle 1.1 Hotend Assembly which takes 3mm plastic filament with a 0.5mm nozzle and an UltiMachine Assembled RAMPS 1.4 electronics with 4 stepper drivers(can be upgraded to 5 for 2 extruders) which have a total value of $280. Both are in perfect working condition and have been used no more than 50 hours without a problem. I am selling these parts just to help pay for college and the fact that I will not have time to 3D print while classes are in session.
The hotend is currently wired for the RAMPS and wire-length accomodates the Prusa i2. If you have a different printer such as the i3,lulzbot or MM2, you may have to re-wire the hotend to fit your needs. I will include the mechanical endstops and wires but I cannot provide the stepper motor wires and connectors because they are permanently wired to my motors, visit UltiMachine.com to order any missing connectors/wires.
What you will receive:
Budaschnozzle 1.1 Hotend 3mm/0.5mm (wired for this board)
Ramps 1.4 Electronics w/4 Stepper Drivers and Arduino MEGA 2560
USB Cable
3 Mechanical Endstops(already wired)
Power Connector
Note to Buyer:
I expect you to already have knowledge of these parts and RepRap. You should already know how to flash and wire these boards. I will not issue a refund for lack of knowledge, I will point you in the right direction however."