Azteeg x3 power issues (no replies)

I am having problems with my new printer board.

I have an Azteeg x3 and had it running the azteeg test code just fine. I down loaded the Repetier firmware uploaded it to the azteeg down loaded the Repetier host. unpluged the board switched the jumper so I could run off of the 12 volt PS. opened the Repetier host and got a connection. I could not get any of the motors to move in manual mode. So I shut everything down and swithced the jumper back, reloaded the test code, switched the jumper powered with 12 v and now that does not run the motor either.

Is there something wrong with this board. I really did not do anything that could have over loaded the components.

Thanks