3 complete/semi complete 3d printers $1600 (no replies)

Hi everyone. I have 3 3d printers which I do not have much time for at the moment. I hope to sell all at once, and once time permits, move onto a newer design. Each printer has upgrades installed. I can advise on some places to get parts replacements if needed.

1. Mendel Prusa I2
No LCD controls
mk1 heatbed
Ramps 1.4 electronics
Wades extruder which needs a new idler printed
All metal hotend (1.75mm)
Marlin firmware installed, which should be calibrated (however my backup firmware was overwritten)
ATX power supply

2. Mendel Huxley
LCD controls
Ramps 1.4 electronics
Have default extruder in a bag, no motor or hotend
Airtripper V3 Bowden setup needs new thermal isolator, but works
Upgraded heat bed -Can print 10 inch parts
Marlin Firmware Calibrated Y, Z AXIS
-needs new gear on belts as there was slipping, very slow print, but worked at slow speeds
Xbox power supply

3. Mendel Prusa I3
Ramps 1.4 electronics with LCD controls
Fully Calibrated X,Y,Z,E Axis
All Metal Extruder for ABS, It will need to be flushed to run PLA
Laser cut frame bolted to wooden base for stability
-Filament does not get stuck in tip, as parts were changed from original extruder, However the feed guide went missing, so sometimes filament does not go into hotend
-Can be prevented by removing cooling fan to insert filament before heatup. Then performs full5+hr prints


Please note, I have not estimated shipping yet