This is the Aluhotend-V6, it is the next version on from the V5C with a few refinements:
- The nozzle has been upgraded with a small round flat around the orifice.
- The heat-sink is now tapped all the way through and a hollow grub screw locking the thermal barrier in place which allows the hotend length to be micro-adjustable which is very handy for those who want to do a dual extruder setup this also means there is nolonger bowden specific version
- The hole for the heater cartridge is smaller measure 6.2mm down from 6.5mm for more contact with the heater cartridges
available on ebay: http://www.ebay.com.au/itm/261647686673?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1558.l2649
and in our webshop: www.3dindustriesaustralia.com.au
Default nozzle size is 0.4mm, 0.3mm and 0.5mm available soon
This hotend requires a fan blowing on the heatsink for proper operation.
* Price includes shipping anywhere in the world via standard Airmail and does not include a tracking number or insurance certain countries maybe excluded due to past trouble with unreliable mail delivery, if you aren't confident in your local mail service use the "pack and send" or "registered post" options available when you make your purchase,
sources and more information is available on the reprap wiki [reprap.org]