[USA] Mendel Max 1.5 with full electronics, hot end, filament ($1100) (no replies)

I have a mendel max 1.5 (black on black - black extrusions and black printed parts) that has been assembled but never printer with. Pretty much just needs end stops installed and then calibrated so it is nearly ready to go! Everything included except glass (comes with aluminum bed). Includes the following:

-Black misumi extrusions
-Black plastic parts
-Rods + leadscrews
-Aluminum bed (Aluminum bed is pre-drilled and countersunk)
-hobbed bolt
-LM8UU's, LM10UU's, 608ZZ bearings, 2 Spiral Z-couplings
-GT2 Belts + Pulleys
-spool holder
-Ramps 1.4 (5 x A4988 stepper driver, 5 x heat sinks, Mega2560 board rev.3, SD Ramps, Smart LCD controller and SD Card reader)
-3 mechanical endstops
-Two MK2 beds (1 is a spare) and neither have been used
-12V DC 30A 360W Regulated Switching Power Supply
-Budaschnozzle 1.2 hot end w/ 0.35mm Nozzle
-Budaschnozzle 1.1 Nozzle .25mm
-Budaschnozzle 1.1 PTFE Tube for 1.75mm Filament
-Heat Resistor 6.8 Ohm
-100k Honeywell Axial Thermistor
-6 NEMA 17 Stepper Motors (5 installed - 1 spare)
-Red PLA 3mm Red 1lb
-Yellow PLA 3mm 1lb
-Black PLA 1.75mm 1lb
-Green Opaque PLA 3mm 1kg on Spool
-ceramic screwdriver

Currently it is assembled and located in Wisconsin but may need to be partly disassembled in order to ship. Reply with any question. I will get pictures posted ASAP.

Thanks,
David