I have a pair of pittman 30v servos with 512 step encoders and built in 5.9:1 gearboxes. They're pulls from an IMServ deskcnc sherline lathe and come mounted to aluminum nema23 adapter plates. I'll sell together or separate. Much more accurate positioning than steppers due to their closed loop nature and over 3000 steps per revolution.
Asking $85ea shipped in the US obo. Pics available if needed.
I bought the lathe without the controller or servo drivers (but did verify they are functional) and would like to do a hybrid conversion using dual shaft steppers (so the manual hand wheels can remain in use). I'll consider partial or full trade for dual shaft nema 23 steppers drivers, and/or a linuxcnc compatible lpt breakout board.
Asking $85ea shipped in the US obo. Pics available if needed.
I bought the lathe without the controller or servo drivers (but did verify they are functional) and would like to do a hybrid conversion using dual shaft steppers (so the manual hand wheels can remain in use). I'll consider partial or full trade for dual shaft nema 23 steppers drivers, and/or a linuxcnc compatible lpt breakout board.